Lowrider
Slim
Rear
Molle
Sherpa Side Panels
Mounting photos
Rotopax water and gas with tread boards above
* tread boards held by a detachable tread boards panel
* tread boards area could be used for a shovel instad
Tread boards top mounted
* same tread board panel as used below
* mount on top, or on the side
Tread boards side mounted at the bottom (3rd position)
Tread boards side mounted in the middle (2nd position)
Tread boards (panel only) side mounted in the middle (2nd position)
* separate panel allows mounting on the side, or on top. Use 4 bolts (included) to mount/dismount the tread boards.
2 Rotopax containers (2 gallons each) fit side by side
* water container can be used while mounted, spout pointing down
* gasoline container has spout pointing up, avoids spills
* side mounted liquids should not experience as much extreme weather as roof mounted
* Shovel is low on the roof, allows garage entry
2 shovels mounted
* top one is 58 inches long, and rests on top of Sherpa. The tip of the handle can be attached to stock rails
* bottom shovel is 40 inches long and rests on the angled surface
Water and Gas mounted
* 2 gallons each
* 4 gallon single wider container support coming
Construction
* separate product for driver's side, another for passenger side
* Aluminum panels won't rust and weigh around 10lb, angled brackets + large panel
* Stainless steel hardware, nylon insert self locking nuts; 3/16 hex head front and 5/16 back nuts
* Rubber pads separate panel from glass
* mounts in 2 parts for easier installation, angled top bracket first
* powder coated black, or raw aluminum for your own custom painting
Usage
* 1 or 2 RotoPax containers sit side by side, 2 gallons each, 1, 1.5...
* tread boards can also be mounted, but will stick out from the back if youurs are 45+ inches long
* all holes (slits and X shapes) are 1/4 inch wide, allow for attaching your own bolts for future accessories
* wide hole strips, vertical and horizontal, allow for strap attachments
* 4 hole square pattern on main panel is for Rotopax mounts (2 1/8 inch square holes fit the square Rotopax bolt mounts)
* customizing: drill your own holes if needed in the future (measure twice)
Reviews
theNewX
- Roofrack reviews (5 pages)
Reddit
- Roofrack by u/loonygecko
theNewX
- Molle reviews (2 pages)
Proudly welded in Tucson, Arizona.
Contact Us
with any questions