• This mount is specific to holding TooLite 550 shovel with a single bolt. Other shovels cannot be mounted to this holder.
• You can mount shovels at 2 points with different holders but to hold it at its center of balance in a single point, that will have to be a custom mount -- as this is
• Longer shovels will hit the roof and not hold in the single mounting spot
• Attaches to Bone and Bone holds on the ladder
• Bone (sold separately) is made from stainless steel an attahes with included round mounts
• Shovel holder is also made of stainless steel
• Both can be left unpainted as in the photo (for the past 2 years)
Shovel Holder
Xterra Shovel
$
0
Shovel holder front
• Philips or hex head bolt with a locking washer
• Back nut is welded on, so all is done from the front
• Out of sign are 2 tabs which slide into square holes
• Removing the shovel: place shovel into the holder; slide 2 tabs into square holes; screw in the single bolt
Shovel holder front
Shovel holder rear
• Single welded on nut holds the shovel on one side
• 2 tabs slide into square holes on the other side
• Top bolt holds Bone to the ladder
Shovel holder rear
Hatch door open
• No interference with roof with this 37 inch shovel
• Longer shovels would not fit the same
• (Older shovel holder design pictured)
Hatch door open
Mounted Shovel in the wild
Mounted Shovel in the wild
Bone mount
• Shovel holder needs to mount to Bone (sold separately)
roXterra
• Shipping to Edmondon and Hawaii in May - your order could save on shipping
